Multiviewers signal
In 
Multiviewers, select one Multiviewer.⚓
In Signal, adjust the following settings:
Setting name | Description / Setting selection |
|---|---|
Pixel Encoding | Auto or RGB Full (8 or 10 bits), RGB Limited (8 or 10 bits), YCbCr 4:4:4 (8 or 10 bits), YcbCr 4:2:2 (12 bits), or YcbCr 4:2:0 (8 or 10 bits) |
Color Space | Auto, ITU-R BT.709, or ITU-R BT.2020 |
DVI mode | Enable to change HDMI signal into DVI signal if using a DVI connector on the Multiviewer display |
DDC Bus Speed | Slow, Medium or Fast (HDMI only) |
HDCP | Disable*; Auto; HDCP 1.x; or HDCP 2.x |
* Disabling HDCP reduces potential problems when the content is not fully HDCP compliant. When output HDCP is disabled, HDCP-protected inputs are not displayed.
Legal : Recommendation⚓
Always use high quality cables to prevent connection and bandwidth errors when using HDCP.
Tip : Good to know⚓
- The actual Pixel encoding and Color space used can be different from the one set in the output format. It is indicated in the details of the signal status in the table.
- DDC Bus Speed is set to Fast by default. Using Slow or Medium speed can be needed to resolve compatibility issues when using HDMI over fiber extenders.