Input signal

In Inputs, select an input.⚓

In Signal, depending on Internal Profile, adjust the following settings:

Setting name

Description / Setting selection

Settings

Signal Type

Auto, YUV, RGB Full (0-255) or RGB Limited (16-235)

Dynamic Range

Auto, SDR, HDR10 or HLG

Luminance

Select the nit level used for this input

SDI Mapping

Auto, Quad Link Four Quadrants or Quad Link 2SI (SDI 2x2 group only)

HDCP

None*, Default, HDCP 1.x Only or HDCP 1.x and 2.x

HDMI/DP/SDI

Interface

Reset the output interface to restore the connection

Conversion Mode

Mode

Auto or LUT

Conversion LUT

In LUT Conversion mode, select a LUT from the Conversion LUT library

Mapping

For SDR with HLG as internal profile only

  • Inverse Tone Mapping: use if if internal processing and main input are using Limited Range color space
  • Direct Mapping

Reference

For HLG ⇔ SSDR conversion only

  • Scene Referred: for camera content
  • Display Referred: for computer content

OETF

Square Rootor Strict

* Disabling HDCP reduces potential problems when the content is not fully HDCP compliant. When input HDCP is disabled, HDCP-protected inputs are not displayed. Please note that for SDVoE connectors, the HDCP status must be specified on the network, using the external SDVoE controller.

AdviceMore information on dynamic range settings⚓

See LivePremier LUT Architecture application note available on www.analogway.com.

Always use high quality cables to prevent connection and bandwidth errors when using HDCP.

AdviceImporting a LUT in the library⚓

See Importing a LUT.